Trouble Shooting - Furrion FGH4ZSA-SS Instructions Pour L'installation Et L'emploi

Before you call for service, review this list. It may save you time and expense. The list
includes common occurrences that are not the result of defective workmanship or
materials in this appliance.
Problem
Burner will not light.
Surface burner
flame burns half
way around.
Surface burner
flame burns half
way around.
Surface burner
flame is orange.
All manuals and user guides at all-guides.com
Important
Possible cause/solution
Surface Control knob has not been completely turned to
LITE. Push in and turn the Surface Control knob to LITE until
burner ignites and then turn control to desired flame size.
Ensure gas supply valve is open.
Burner ports or slots are clogged. With the burner off, use a
small-gauge wire or needle to clean ports or slots.
Check gas supply levelin bottles.
Battery power insufficient. Unscrew ignitor cap and replace
AA battery.
Moisture is present on the burner, dry burner thoroughly.
Burner ports or slots are clogged. With the burner off, clean
ports with a small-gauge wire or needle to clean ports or
slots.
Moisture is present after cleaning. Lightly fan the flame and
allow burner to operate until flame is full. Dry the burners
thoroughly following instructions under General Cleaning.
Dust particles in main line. Allow the burner to operate a few
minutes until flame turns blue.
In coastal areas, a slightly orange flame is unavoidable due to
salt air.

Trouble shooting

15