Black & Decker BDP3100 Manuel D'utilisation page 11

All manuals and user guides at all-guides.com
caution:
* the high pressure spray from your pressure washer is capable of
causing damage to surfaces such as wood, glass, automobile paint, auto strip-
ing and trim, and delicate objects such as flowers and shrubs. Before spraying,
check the item to be cleaned to assure yourself that it is strong enough to resist
damage from the force of the spray.
1. Pull quick­
connect cou-
pler back and
insert nozzle.
2. Release quick­
connect cou-
pler and twist
nozzle to make sure it is secure in
coupler.
Warning: flying object could
cause risk of serious injury. ensure
nozzle is completely inserted in quick-
connect socket and quick-connect
snap ring is fully engaged (forward)
before squeezing gun trigger.
how to apply chemicals/cleaning
solvents
applying chemicals or cleaning solvents
is a low pressure operation. note: use
only soaps and chemicals designed
for pressure washer use. do not use
bleach.
to apply chemicals:
1. press chemical
hose (p) onto
barbed fitting (t)
located near high
pressure hose
connection of
pump as shown.
2. place other end of chemical hose
with filter on it into container hold-
ing chemical/cleaning solution.
note: for every 7 gallons of water
pumped 1 gallon of chemical/
cleaning solution will be used.
3. install low pressure (black) noz-
zle into quick connect fitting of
spray wand, see how to use
spray Wand paragraph in this sec-
tion.
4. after use of chemicals, place
chemical hose into container of
clean water and draw clean water
through chemical injection sys-
tem to rinse system thoroughly. if
chemicals remain in the pump it
could be damaged. pumps dam-
aged due to chemicals will not be
covered under warranty.
note: chemicals and soaps will not
siphon when spray wand is in the high
pressure setting.
Warning: to reduce the risk
of injury, read the pressure washer
instruction manual and the engine
instruction manual before starting
pressure washer.
danger: risk of fluid injection
and laceration. When using the high-
pressure setting, do not allow the
high-pressure spray to come in con-
tact with unprotected skin, eyes, or
with any pets or animals. serious
injury will occur.
• Your washer operates at fluid pressures
and velocities high enough to penetrate
human and animal flesh, which could
result in amputation or other serious
p
injury. leaks caused by loose fittings or
worn or damaged hoses can result in
t
injection injuries. do Not treat fluid
iNJectioN as a simple cut! see a
physician immediately!
Warning:
asphyxiation and Burn. never fill fuel
tank when engine is running or hot.
do not smoke when filling fuel tank.
• NEvER fill fuel tank completely. fill tank
to 1/2" )12.7 mm) below bottom of filler
neck to provide space for fuel expan-
sion. Wipe any fuel spillage from engine
and equipment before starting engine.
• NEvER run engine in doors or in en closed,
poorly ven ti lat ed areas. en gine exhaust
con tains carbon mon ox ide, an odorless
and deadly gas.
11 - eNg
risk of fire,
N002453