Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Navion
LED Area/Site Luminaire Installation Instructions
™
Photocontrol (If Equipped)
1.
Using a flat blade screw driver, loosen the two
flathead screws to allow rotation of the receptacle.
2.
Insert screwdriver into center slot and rotate
receptacle until indicator arrow points north or
desired direction.
3.
Tighten screws.
4.
Insert the photoelectric control (or shorting cap) into
receptacle and twist into locked position.
Note: The photocontrol must contain a soft, resilient
gasket fastened to the bottom surface to assure a
proper weather seal between the control and the
receptacle.
Maintenance
Note: A regular maintenance schedule should be
followed to retain optimal light output and thermal
performance.
Optical lens cleaning should be performed with
a clean dry cloth to remove any dust or other
contaminants. Additional cleaning can be
performed with non-abrasive acrylic cleanser.
Remove any dirt, leaves or other foreign debris
from the housing and fins. Clean water may be
used to flush the fins.
Field Adjustable Drive Current (FADC) Option Only
(If Equipped) FIG. 5
1.
Connect grey driver wire to grey resistor pack wire.
2.
To change current to 525mA, connect purple
driver wire to purple resistor pack wire.
3.
To change current to 700mA, connect purple
driver wire to yellow resistor pack wire. (For Navion
with 1 Light Square, connect purple driver wire to
orange resistor pack wire).
4.
Position and secure all wires away from all other
electrical components (drivers, terminal blocks).
5.
Close access door and secure latches.
4
COOPER LIGHTING SOLUTIONS
All manuals and user guides at all-guides.com
FIG. 5
IB500024EN
Installation instructions
Yellow Resistor
Pack Wire
Grey Resistor
Pack Wire
Purple Resistor
Pack Wire
Resistor Pack
Driver
Grey Driver Wire
Purple
Driver
Wire
Publicité
Table des Matières
