Navion ™ Led Area/Site Luminaire Installation Instructions; Installation Instructions; Tools Required - Cooper Lighting Solutions Navion LED Instructions D'installation

Navion LED Area/Site Luminaire Installation Instructions
™

Installation Instructions

Tools Required

Ratchet, 9/16" socket, flat blade screw driver, electrical
wiring tools.
Installation
1. With housing lying on a smooth, soft surface open
the access door by releasing the side latches. Door
may be removed by opening approximately 130°
and lifting off the hinge. FIG. 1
2. Using a 9/16" socket, loosen the four (4) pipe clamp
mounting bolts enough to allow mounting arm (not
included) to slide onto leveling steps. FIG. 2
Note: For 1.5" pipe size, use seal unmodified. FIG. 2a
Note: For 2" pipe size, tear off seal along dotted line.
Gasket has a weak edge for easy tear off. Pipe to
be inserted after seal tear off. FIG. 2b
3. Close access door. Lift the housing into place,
re-open access door, and position end of mounting arm
onto leveling steps so that housing is level. Care must
be taken so arm does not inadvertently strike internal
components. To avoid potential
damage to fixture, ensure housing is level both front to
back and side to side by placing level on flat surface on
top of the housing.
4. Using a 9/16" socket tighten the four (4) pipe clamp
mounting bolts to 16-18 ft-lbs. FIG. 2
FIG. 1
Latch
Optional Photocontrol Receptacle
2
COOPER LIGHTING SOLUTIONS
All manuals and user guides at all-guides.com
FIG. 2
FIG. 2a
1.5" INCH PIPE
FIG. 2b
2" INCH PIPE
Door
120°
Hinge
5. Wiring
1.
2.
IB500024EN Installation instructions
(2) Pipe Clamps
Leveling Steps
DETAIL B
SCALE 1:2
IP66 TEAR
OFF GASKET
Pull service wires through mounting arm and into
housing approximately 10" .
a. Three-terminal block (2-wire service): Connect line
service lead to terminal that is connected to black
factory-installed wire. Connect neutral service
wire to terminal that is connected to white factory-
installed wire.
Bird Guard
(4) Bolts
SEAL TO BE USED
UNMODIFIED FOR
1.5" SIZE
DETAIL A
SCALE 1:2
PIPE TO BE
INSERTED AFTER
SEAL TEAR OFF
FOR 2" PIPE SIZE TEAR OFF
SEAL ALONG DOTTED LINE.
(GASKET HAS A WEAK EDGE
FOR EASY TEAR OFF)