Samsung HT-E6530 Guide D'utilisation page 56

Appendix
Settings
56
|
English
HT-E6530_ZC_0315.indd 56 HT-E6530_ZC_0315.indd 56
All manuals and user guides at all-guides.com
Anynet+ (HDMI-CEC)
• Depending on your TV, certain HDMI output resolutions may not work. Please refer to the user
manual of your TV.
• This function is not available if the HDMI cable does not support CEC.
• If your Samsung TV has an Anynet+ logo, then it supports the Anynet+ function.
BD Data Management
• In the external memory mode, disc playback may be stopped if you disconnect the USB device in
the middle of playback.
• Only those USB devices formatted in the FAT file system (DOS 8.3 volume label) are supported.
We recommend you use USB devices that support USB 2.0 protocol with 4 MB/sec or faster
read/write speed.
• The Resume Play function may not work after you format the storage device.
• The total memory available to BD Data Management may differ, depending on the conditions.
Front Display
• You cannot change the brightness of the
Speaker Settings
• When Speaker Selection is set to TV Speaker, audio is produced through the TV speakers.
• Running the Auto Sound Calibration function takes about 3 minutes.
• Make sure there is no disc in the product when you run the Auto Sound Calibration function.
• If the ASC microphone is disconnected during the Auto Sound Calibration setup, the setup will be
canceled.
• When the Auto Sound Calibration function is activated, the DSP, Dolby Pro Logic ll and SFE Mode
will not work.
• If the product is connected to external devices or other components (such as an iPod, AUX,
D. IN), the Auto Sound Calibration Setup may not work properly.
HDMI audio
• When HDMI audio is output to the TV speakers, it is automatically down-mixed to 2 channels.
Audio Return Channel
• When Anynet+ (HDMI-CEC) is Off, the Audio Return Channel function is not available.
• Using an HDMI cable not certified for ARC (Audio Return Channel) may cause a compatibility
problem.
• The ARC function is only available if an ARC-compliant TV is connected.
Digital Output
• Digital Output can be activated when Speaker Selection is set to TV Speaker.
button and the VOL +, - button.
2012-03-15 오후 4:39:05 2012-03-15 오후 4:39:05