Usb Power Port; Worklight - Wagan Tech 300 Amp Battery Jumper 2467 Guide D'utilisation

300 Amp Battery Jumper™ by Wagan Tech

USB POWER PORT

You may operate the USB port and DC sockets at the same time.
1. Connect a user-supplied USB cable to the USB power port on the Battery Jumper.
2. Set the USB/Worklight Switch to the "|" position.
3. When charge is complete, set the USB/Worklight Switch back to the "O" position.
4. Disconnect the USB cable from the Battery Jumper.

WORKLIGHT

You may operate the worklight and DC sockets at the same time.
1. Set the USB/Worklight Switch to the "||" position.
2. The 5 LEDs will illuminate.
3. Turn the light off when it is not in use.
14
www.wagan.com
®