Eldom Invest WV03039/72269WN Guide D'installation, Utilisation Et D'entretien page 13

moisture.
The rules for checking the corrosion protection and anode
replacement (please refer to previous section), as well as removal
of the accumulated limestone, must be strictly observed both during
and after the appliance warranty period.
During the appliance usage and maintenance do not damage the
metal plate with its technical data and serial number. Should you
take it off, keep it with the warranty form because it is the document
serving to identify the water heater.
FAILURES
When the heater does not heat the water, check if the external
disconnecting device is not switched off, if the lighting key is
switched off and if the thermostat knob is not turned to the lowest
position.
If the power supply is in order, the lighting key is switched on and
the thermostat knob is turned to its highest position, but the water
in the appliance is still not warming (it is possible that the lighting
key or the signal lamp are lighted or not), using the external
disconnecting device unplug the heater and contact the nearest
authorized service company.
In case when from the mixer at completely open tap for hot water
there is no leakage or water flow is weak, check if the filter at the
mixer outlet is not clogged, or whether the shut-off valve before the
heater is not fully or partially closed (4, Fig. 8), or if water supply is
not stopped. If all listed above causes are not the cause of failure,
using the external disconnecting device unplug the heater and
contact the nearest authorized service company.
When the water heater is equipped with electronic control board, at
the end of the additional instruction manual are listed the error
messages appearing on the display in case of failure and what
measures to take for each case. In any other general case of
failure, using the external disconnecting device unplug the heater
and contact the nearest authorized service company.
In case of failure of the power cord and/or plug for water heaters
with such, contact the nearest authorized by the manufacturer
service company as the cord with plug must be replaced by the
manufacturer, its service agent, or a person with similar
qualifications in order to avoid danger.
WARRANTY, WARRANTY PERIOD AND
WARRANTY CONDITIONS
The warranty, warranty conditions, warranty period, warranty
validity for purchased appliance and service related manufacturer
or vendor liabilities during the appliance warranty period are listed
in the appliance warranty form. When buying the appliance the
warranty form must be filled and signed both by seller and buyer.
Keep the warranty form in a secure place.
In all instances shall be in force the applicable laws, regulations
and other legislation dealing with the rights and obligations of
consumer, seller and manufacturer, and their relationships related
to purchased water heater, its installation, use, servicing and
maintenance.
Warranty term is determined by seller and is in force only for the
geographical territory of the country.
Warranty is valid only if the appliance:
Is installed according to the requirements for installation and
џ
operation.
Is used only as per designed purpose and in accordance with
џ
the installation and operation manual.
Warranty consists of free of charge repair of all factory defects,
which may arise during the warranty term. Repair is performed by
service specialists, authorized by seller.
Warranty is not valid for damages, caused by:
Improper transportation
џ
Improper storage
џ
Improper usage
џ
Parameters of water, different from the admissible norms for
џ
quality of drinking water, and particularly if the composition of
chlorides is more than 250 mg/l; the electrical conductivity is
less than 100 μS/cm and pH is outside of 6,5-8 for water
heaters with enameled water tanks; the electrical
conductivity is more than 200 μS/cm for water heaters with
water tanks made of chrome-nickel steel.
Supply voltage, different than the unit's rated voltage.
џ
Damages due to freezing of water.
џ
Elemental perils, disasters and other force majeure
џ
circumstances.
Non observance of the installation and operation manual.
џ
In cases, when a non authorized person has tried to repair
џ
any kind of a defect.
In the above cases the defect will be repaired against relative
payment.
Warranty shall not apply to normal wear parts and components of
the device, parts that are being removed during normal use,
lighting and signal lamps and the like, changing the color of
external surfaces, change of shape, size and location of parts and
components that are exposed to impact and conditions that are not
considered normal use.
Lost profits, tangible and intangible damages caused by
temporary inability to use the device during its prevention and
repair shall not by covered by the warranty.
COMPLIANCE WITH THE REQUIREMENTS OF THIS
INSTRUCTION MANUAL IS A PREREQUISITE FOR SAFE
OPERATION OF YOUR PURCHASED PRODUCT AND IS ONE
OF THE WARRANTY TERMS AND CONDITIONS.
IT IS ABSOLUTELY PROHIBITED TO THE USER OR ANY
AUTHORIZED BY HIM PERSON TO UNDERTAKE ANY
CHANGES IN THE PRODUCT DESIGN AND STRUCTURE.
ANY FINDING OF SUCH ACTIONS OR ATTEMPTS SHALL
AUTOMATICALLY RENDER VOID ALL WARRANTY
LIABILITIES OF SELLER OR PRODUCER.
IN CASE OF NECESSITY FOR SERVICE SEEK ONLY
MANUFACTURER AUTHORIZED SERVICE COMPANIES
LISTED IN THE ANNEXED FORM.
THE MANUFACTURER PRESERVED HIS RIGHT TO
STRUCTURAL CHANGES WITHOUT NOTICE WHERE SUCH
SHALL NOT AFFECT PRODUCT SAFETY.
EN
13