Lubrication - Facom NS 1400F Notice Originale

Fig. 1
FORWARD
Forward rotation can be adjusted for variable speed by turning the button from low to high as shown. For maximum forward
torque (Fig. 2), turn knob until the indicator line matches with '+' symbol. For low forward torque turn knob until the indicator
line matches '-' symbol.
Fig. 2
PROPER HAND POSITION
Warning: To reduce the risk of serious personal injury, ALWAYS use proper hand position as shown
(fig.3).
Warning: To reduce the risk of serious personal injury, ALWAYS hold securely in anticipation of a
sudden reaction.
MAINTENANCE

Lubrication

Air tools require lubrication throughout the lifetime of the tools.
The impact wrench mechanism uses compressed air to power the tool. The compressed air contains moisture that will rust the compo-
nents inside of the tools, therefore lubrication is required daily. Failure to lubricate the air tool properly will dramatically shorten the life of
the tool and will void the warranty
CAUTION: This air tool requires lubrication BEFORE initial use, also before and after each additional use.
To Lubricate the Air Tool Manually:
1. Disconnect the tool from the air supply source, place the air inlet face up.
2. Depress the trigger and place about 0.25 to 0.5 ml of air tool oil into the air inlet.
NOTE: Use SAE #10 weight oil if air tool oil is not available.
3. Remove accessory, connect the tool to an air source, then cover the exhaust end with a towel and run tool for 2 to 3 seconds.
To lubricate internal mechanism:
Locate the grease fitting in the back of the tool. Inject 4 cc's of approved impact grease into the fitting every 3-6 months depending on
use.
WARNING: Keep out of the reach of children. If air tool oil is ingested, do not induce vomiting, call a doctor immediately.
WARNING: Any excess oil in the tool is immediately expelled from the exhaust port. Always direct exhaust port away from
people or objects.
NOTE: Check the speed and make a simple check of the vibration level after each service.
NU-NS.1400F_0517.indd 10
REVERSE
WARNING
10
Fig. 3
16/05/2017 08:38:17