Maintenance; Replacing The Batteries; Storing The Instrument; Cleaning - Chauvin Arnoux C.A 6630 Notice De Fonctionnement

English
For maintenance, use only the specified spare parts. The manufacturer
cannot be held liable for any accidents that occur following maintenance and
repairs carried out by anyone other than its after-sale service department or
approved repair and maintenance professionals.
7.1

REPLACING THE BATTERIES

The appearance of the
charge is too low for carrying out further measurements.
The batteries must then be replaced: 6 x 1.5V batteries (AA type).
Battery replacement procedure :
•
disconnect all measurement leads
•
switch the instrument off
•
open the battery compartment on the rear panel of the instrument (1 screw
to be unscrewed)
•
replace the used batteries with new batteries of equivalent specifications
•
close the battery compartment
7.2

STORING THE INSTRUMENT

If the instrument is to be stored for a period of more than 2 months, remove the
batteries.
7.3

CLEANING

It is imperative that the instrument be disconnected from any source of electricity.
Use a soft cloth, dampened with soapy water. Rinse with a wet cloth and dry
quickly using a dry cloth or propulsed air dryer. Do not use alcohol, hydrocarbons,
or other solvents.

7 MAINTENANCE

symbol on the display unit indicates that the battery
35
www.electronicaembajadores.com
Battery Tester C.A 6630