Seiko GPS Solar Manuel D'instructions page 9

3
Direct the watch face upward and wait
 Please note that it may be difficult to receive GPS
signals while you are in motion.
It takes a maximum of 2
minutes to complete reception.
 It depends on the receiving
conditions.
< Display during reception (= satellites
acquisition status) >
The second hand indicates ease of receiving
(= number of GPS satellites from which GPS
signals are received).
 The larger the number of
0 units
acquired satellites, the
easier it is to receive GPS
signals.
Second hand position
25-second
・ ・
Number of satellites 5 units
・
6 units
5 units
 Even when the hand points to
4 units or more, reception
may not be allowed.
 To cancel the reception, press
Button B.
14
When the second hand points to "Y" or "N,"
4
reception is completed.
The reception result is displayed for 5
seconds.
Then, the hour and minute hands move, and
the time and date are adjusted. (The time
zone is also adjusted to the local time zone.)
Reception
Y: Successful N: Failed
result display
Display
Check that the reception is successful after
the watch returns to the time display mode.
2 units
 During movement of the hands and the date, the
3 units
May receive buttons cannot be operated.
4 units
 Manually set Daylight Saving Time (DST).
Press
Precautions on time zone adjustment
If the time zone is adjusted near a time zone boundary, the time of the adjacent time zone
may be displayed.
In some areas the boundaries observed by the watch may not exactly correlate to the actual
time zone markers on the land.
This does not indicate a malfunction. In this case, set the time zone in the manual time zone
setting mode.
When the time zone is adjusted while traveling on land, avoid doing so near time zone
boundaries. In addition, when the watch is used near time zone boundaries, make sure to
check the time zone setting, and manually set the time zone as necessary.
15