Steps For Installation; Installing Your Washer - Haier HLT23E Guide De L'utilisateur

All manuals and user guides at all-guides.com

Steps for Installation

• Select a suitable location for the washer on a hard even surface away from direct
sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances etc.
Any floor unevenness should be corrected with the leveling legs located on the
bottom corners of the washer. The washer must be placed at room temperature.
You must not place washer where the temperature is at below freezing.

Installing Your Washer:

Read install instructions carefully before installation.
Caution: If, after completing these steps, you are unsure that unit is properly
installed, contact a qualified installer. To ensure that your Washer is prop-
erly installed it is recommended that it be installed by a
certified installer.
1. Insert a new flat washer into each end of the inlet hoses. Firmly put the
washers in the coupling.
Note: You may have to use pliers to tighten the coupling. Do not over tighten
because you may cause damage to the valve.
2. Connect the hot and cold water inlet hoses to the hot and cold
water faucet.
English
16