Manual Operation; Maintenance, Cleaning, Storing And Transport - Westfalia 93 78 18 Instructions Originales

Manual Operation

For manual operation you have to reposition the
float switch at a higher level or to keep the float
switch up by hand. By doing this the water can
be pumped up completely. An automatic cutoff
does not occur.
Do not operate the pump unsupervised during
manual operation. Disconnect the pump from
power mains as soon as the water level falls
below 3.5 cm. Otherwise, the pump will run dry
long and can be damaged.

Maintenance, Cleaning, Storing and Transport

▪ Unplug the power plug before undertaking any kind of maintenance
work or before cleaning.
▪ The pump does not require maintenance apart from occasionally
cleaning the housing and the strainer.
▪ When opening covers or removing casing parts you may expose live
parts. Capacitors inside the device may still carry voltage even
though they have been disconnected from all voltage sources.
▪ In case the pump pumped fluids, which leave residue, it should be
thoroughly cleaned after use with clean water. Sand, mud or
suspended sediment in the pumped water can affect its delivery
rate.
▪ To thoroughly clean the turbine wheel, unscrew the screws and take
apart the base from the upper housing. Clean dirt with a brush etc.
Rinse the pump with clear water.
▪ Never use corrosive or acidic cleaners to clean the pump.
Operation
20
2