OVERVIEW
1.
Platter
Place your record here.
2.
45RPM Adaptor
This adaptor allows you to play 45RPM
records.
3.
Tone arm
The fixed tonearm can be raised and lowered
by hand, or by pressing the raise / lower
lever.
4.
Tone arm Lever
Raises and lowers the tonearm.
5.
33 / 45 / 78 RPM Switch
This switch controls the RPM of the turntable
platter.
6.
Autostop Switch ON/OFF
This switch turns auto stop on or off. When
the automatic stop is enabled, the platform
will start rotating as soon as the tone arm is
placed over the record and will stop rotating
when it has reached the end of the record.
Some vinyl records stop before the end or do
not stop when the end is reached. In this case
set Auto-stop to OFF.
7.
Arm Clip
This specially designed arm clip secures the tonearm while at rest or when not in use. The arm clip has been designed
to remain in the up position while unlocked.
8.
Cartridge with needle
When the turntable is not in use, it is recommendable to place
the removable protection cover on the stylus.
9.
USB port
Use the included USB cable to connect your turntable to your
computer. The USB connection will send audio from the turntable
to your computer
10. Line output
The audio from a playing vinyl record is sent to this line-level coaxial audio output. This must not be connected to
phono level devices.
OPERATION
1.
Connect the record player with the power adapter and plug the other end into a wall power outlet.
2.
Remove white protective needle cover by gently pulling towards the front of the unit.
3.
Place a vinyl record on the turntable platter and select the desired speed (33/45RPM) according
to the record.
4.
Open the tone arm clip to release the tone arm. Gently move the tone arm and put the cartridge
onto the desired position of the record and the turntable player starts to play.
Noted: If the AUTO STOP ON/OFF Switch is turned ON, the record will stop automatically when finished.
If Auto Stop Control is turned OFF, record will NOT stop automatically when finished.
4