Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
High sensitivity
Medium Sensitivity
Connecting to the Control Panel
Please connect the detector with control panel before use:
1. Make sure the control panel is under pairing state (please refer to
the relative user manual).
2. Knock once on the surface of the detector to simulate an alarm (LED
flashes once), when a beep is heard from control panel, it means
the pairing is successful.
Installation
1. Remove the insulating strip; the detector will enter working state.
2. Clean the surface of object to be installed.
3. Fix the detector on the middle of the object's surface with double-
sided adhesive tape and make sure the antenna is upward.
All manuals and user guides at all-guides.com
Low sensitivity
Note:
Whether a vibration signal will be detected depends on not only the knocking
strength on objects, but also the strength, frequency and duration of the signal.
Specifications
Power Supply:
DC 3 V (AAA 1.5 V LR03 x 2 PCS)
Static Current:
< 29 uA
Alarm Current:
< 22.2 mA
Transmitting Distance:
< 80 m (in open area)
Radio Frequency:
868 MHz or 915 MHz
Housing Material:
ABS plastic
Operation Condition:
Temperature: -10°C ~ +55°C
Relative Humidity: < 80% (non-condensing)
Detector Dimensions (L x W x H):
54 X 14.5 X 107 mm
EN
Publicité
Table des Matières
