Würth VSG 80 Traduction Des Instructions De Service D'origine page 17

Adjusting the screw-in depth (Fig. IV)
The screw-in depth can be continuously adjusted by
turning the nut [15].
Note
The set screw [26] must be loosened
using a 2.5 mm Allen key before the
nut [15] is turned.
Clockwise rotation:
The depth stop moves down.
3
The screw head is screwed in further.
3
Anticlockwise rotation:
The depth stop moves up.
3
The screw head is not screwed in so far.
3
Note
The necessary screw-in depth is de-
pendent on the material and must be
determined by trial and error.
▸
Retighten the set screw [26].
Lubrication (Fig. I/IX)
▸
Prior to initial use, lubricate the guide tube [17]
with the supplied maintenance oil.
Operation
Attention!
Risk of machine damage!
If there are multiple self-drilling screws in the
device, it can result in severe machine damage.
Ensure that only one self-drilling screw is
¾
contained in the machine.
Switching ON/OFF
▸
Switching on: Press the on/off switch [5] and lock
with the lock button [4].
▸
Switching off: Press the on/off switch [5] again
and then release.
Continuous speed adjustment
▸
Use the setting wheel [7] to preselect the max-
imum speed.
▸
The machine continues to run for as long as the
on/off switch [5] is pressed at a speed variable
between 0 and maximum.
All manuals and user guides at all-guides.com
Gear selection
Attention!
Risk of machine damage!
Changing the gear with the machine running can
result in severe machine damage.
Only change the gear if the machine is
¾
stationary.
▸
Turn the gear selector switch [21] until it engages
in the relevant position.
Screwing
▸
Position the device over the screwing location.
▸
The markings [28] on the base plate [13] and
centring unit [12] (Fig. VI) are to simplify set-up.
▸
Place both feet on the base plate and stand with
your centre of gravity forward over the pressure
point [29] (Fig. VII).
▸
Drop the self-drilling screw with the tip downwards
into the insertion opening [3].
Attention!
Risk of machine damage!
If there are multiple self-drilling screws in the
device, it can result in severe machine damage.
Ensure that only one self-drilling screw is
¾
contained in the machine.
▸
Firmly hold handle [6] and auxiliary handle [2]
with both hands and switch on the device.
▸
Press lever [1]
The compressed air cylinder [16] guides the
3
device downwards.
Risk of burns!
Screwing location and screw head may
be hot.
Do not touch the screwing location or
¾
screw head.
Allow the screwing location and
¾
screw head to cool.
Attention!
Smoke formation!
Smoke may form from the burning of wood chips /
coatings. Any smoke that may arise is harmless.
Ensure good ventilation of the work area.
¾
CAUTION!
17