Door Reversal Instructions - Danby Designer DUF167A4WDD Manuel Du Propriétaire

OPERATING INSTRUCTIONS

DOOR REVERSAL INSTRUCTIONS

If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove one screw from top hinge cover (A) and
then remove top hinge cover.
2. Remove four screws from top hinge (B) and then
remove top hinge, top door spindle (C) and top
hinge spacer (D).
3. Remove door from unit and set aside. Ensure
that you do not damage the bottom door
spindles (F).
4. Remove roller caps at bottom of unit (E).
5. Remove four screws each from both bottom
hinges and then swap the bottom hinges (J).
Ensure that the C-shaped hinge is on the side of
the unit opposite the handle.
6. Reinstall four screws each in both bottom hinges
(F).
7. Reinstall the bottom door spindles (F and G).
8. Reinstall the roller caps at the bottom of the unit
(E).
9. Reinstall the door and ensure that the bottom
door spindle (F) is placed in the hole in bottom
hinge that is closest to the outside of the unit.
10. Replace hinge spacer (D), replace top door
spindle (C), reinstall top hinge with four screws
(B). Ensure that you fl ip the top hinge to its
opposite side so that the top door spindle is in
the correct position.
11. Reinstall the top hinge cover (A) with one screw.
A top hinge cover for the opposite side of the
unit can be found in the accessory bag inside
the unit.
Note: When installing the door, ensure that the top
of the door is level with the top of the cabinet. If the
door is not level, the rubber gasket will not make
a good seal with the cabinet which can cause the
appliance to malfunction.
5