SilverCrest SHBS 500 D4 Mode D'emploi page 22

DANGER! Risk of electric
shock
Never put the device into operation if
there are visible damages to the device,
the power unit or the cable or if the de-
vice has been dropped before.
Connect the cable to the device before
plugging the power unit into a wall
socket.
Only connect the power unit to a prop-
erly installed, easily accessible wall
socket, the voltage of which corre-
sponds to the specifications on the rat-
ing plate. The wall socket must continue
to be easily accessible after the device
is plugged in.
Ensure that the cable cannot be dam-
aged by sharp edges or hot surfaces.
Ensure that the cable is not trapped or
crushed.
When removing the power unit from the
wall socket, always pull the power unit
and never the cable.
Pull the power unit out of the wall socket ...
... after every use,
... after each charging process,
... if there is a fault,
... before connecting the device to the
cable,
... before you clean the device, and
... during thunderstorms.
To avoid any risk, do not make modifi-
cations to the device. Repairs must be
carried out by a specialist workshop or
the Service Centre.
DANGER from batteries
This device contains a battery that can-
not be removed. The battery may only
be removed or replaced by the manu-
facturer, the manufacturer's customer
service department or a similarly quali-
fied specialist, in order to avoid any
hazards.
20 GB
All manuals and user guides at all-guides.com
Protect the battery against mechanical
damages. Fire hazard!
Do not expose the device to direct sun-
shine or heat. The ambient temperature
should not be lower than -10 °C and
higher than +40 °C.
The charge contacts on the device must
not be connected by metallic objects.
The battery may only be charged with
the original accessory (power unit).
Should the electrolyte solution leak out
of the battery, avoid contact with eyes,
mucous membranes and skin. Rinse im-
mediately with plenty of clean water
and consult a doctor. The electrolyte
solution can cause irritation.
WARNING! Risk of injury from
cutting
The tips of the comb attachments and
shaving head are sharp. Handle with
care.
Do not use the device if the attachment
shows damages.
Switch off the device before pinning up
or changing the attachments and each
time before cleaning.
WARNING! Risk of injury
Place the cable in such a way that no
one trips over it or steps on it.
Do not use the device on open wounds,
cuts, sunburn or blisters.
WARNING! Risk of material
damage
Only use the original accessories.
Never place the device on hot surfaces
(e.g. hob plates) or near heat sources or
open fire.
Do not cover the power unit to prevent
overheating.
The blades of the shaving head may be
cleaned with water. Do not use any oth-
er liquids.
Do not use any astringent or abrasive
cleaning agents.