Table des Matières
Publicité
EC 884 PJ
CONTROLS AND DISPLAY
1. Display.
2. Time.
3. Alarm symbol 1.
4. Alarm symbol 2.
5. Date.
6. Day of the week.
7. Indoor temperature.
8. Indoor humidity.
9. Projection arm.
10. LIGHT/SNZ/PROJECTION button, activate the backlight (approx.
8 seconds)/ stop the alarm for 5 minutes.
11. TIME button, set the Time mode.
12. ALARM button, set the Alarm mode.
13. UP button, increase the current set value.
14. DOWN button, decrease the current set value/ switch between
°C and °F.
15. ON/OFF switch for alarm 1.
16. ON/OFF switch for alarm 2.
17. ROTATE button, rotate the projection by 0°, 90°, 180° or 360°.
18. Power supply unit connection socket.
19. Battery compartment.
20. USB charging port.
GETTING STARTED
INSERTING THE BATTERIES/ CONNECTING THE POWER SUPPLY
1. Connect the power supply unit to the power supply unit con-
nection socket (18) on the back of the projection alarm clock;
2. Connect the power cable of the projection alarm clock to a
properly installed socket;
3. The projection alarm clock switches on automatically;
CLOCK PROJECTION
4. Alternatively, open the battery compartment (19), insert two
AAA batteries with the correct polarity and close the battery
compartment cover.
Note:
• If the batteries are inserted correctly and you connect the power
supply unit to the alarm clock, the projection alarm clock will
automatically switch to the external power supply.
• Sustained projection is only possible on mains power.
REPLACING THE BATTERIES
1. Open the battery compartment (19) on the back of the product;
2. Remove and dispose of any used batteries. Insert two new
batteries (AAA). Ensure that the polarity of the battery corre-
sponds to the symbols in the battery compartment;
3. Close the battery compartment (19).
OPERATION
SETTING THE DATE/TIME
Once you have inserted the batteries or connected the power supply
unit, the display is switched on, an acoustic signal sounds and the
alarm clock automatically starts.
1. Press and hold the TIME button (11) for approximately 3 seconds
until the display begins to flash;
2. Set the following information in the order listed:
12/24-hour format
Month Date
Year
language
Exit;
3. To select individual values, press the UP button (13) or the
DOWN button (14) and confirm each selection by pressing
the TIME button (11);
4. Press the TIME button (11) immediately to adopt the set value
display and skip ahead;
5. If you do not make an entry for 20 seconds, Settings mode is
exited automatically.
Note
Day of the week language:
You can choose from German (GE), French (FR), Spanish (SP),
Italian (IT), Dutch (DU), Danish (DA) and English (EN) for the display
of the day of the week.
TEMPERATURE DISPLAY
Press the DOWN button (14) to choose between °C and °F for the
temperature display.
ALARM CLOCK
SETTING THE ALARM TIME
1. Press and hold the ALARM button (12) for approx. 3 seconds
to go to Alarm mode. The display begins to flash;
2. Set the following information in the order listed:
Alarm 1 (3): hours
minutes;
3. Press the UP button (13) or the DOWN button (14) to select the
hour for the alarm time and confirm your selection by pressing
the ALARM button (12). The minutes display begins to flash;
4. Repeat the process to set the minutes for the alarm time;
5. Press the ALARM button (12) immediately to adopt the set
value display and skip ahead;
6. If you do not make an entry for 20 seconds, Settings mode is
exited automatically.
ENGLISH
Hour
Minute
Date Month or
Month
Day
Day of the week
minutes
Alarm 2 (4): hours
7
7
Publicité
Table des Matières
