Lavorwash THERMIC 2W / PRO Notice Technique - Utilisation Et Entretien page 23

PROBLEMS
Poor detergent suction
No water coming through
the nozzle.
CAUSES
The nozzle holder head (24) is not
in the low pressure position (Fig. 3
- Position b).
Detergent suction filter (40) clogged. Follow the instructions given in the
The detergent being used is too
viscous.
No water.
Suction depth is excessive
Water nozzle clogged.
REMEDIES
Proceed as explained in Fig. 3 - Position a.
"r M " paragraph.
outine aintenanCe
Use a detergent recommended by the
manufacturer and follow the diluting
instructions on the label.
Check that the mains water tap is fully
open or that the suction hose is able to
prime.
Make sure priming depth conforms to
what is specified in the "s
" paragraph.
teChniCal data
Clean and/or replace the nozzle as
explained in the "r
outine
paragraph.
EN
peCiFiCations and
M "
aintenanCe
23