Requirements For Use - Festo DDLI-25 Notice D'utilisation

DDLI-25/32/40/63
4

Requirements for use

Note
Malfunctions will occur if the device is not used correctly.
• Make sure that the specifications contained in this chapter are adhered to at all
times.
• Take into consideration the legal regulations applicable for the destination, as well as:
– regulations and standards,
– regulations of the testing organizations and insurers,
– national specifications.
• Note the warnings and instructions on the product and in the relevant operating instructions.
• Remove all transport packaging, such as plastic sheets, caps and cartons (except for any covers in
the pneumatic ports).
The material used in the packaging has been specifically chosen for its recyclability (exception: oil
paper = residual waste).
• Observe the local regulations for environmentally friendly waste management of electronic compon-
ents.
• Take into account the material specifications (
• Use the product in its original status, without any unauthorised product modifications.
• Take into consideration the ambient conditions at the location of use.
Corrosive elements in the environment (e.g. ozone) will reduce the service life of the product.
• Compare the maximum values specified in these operating instructions with your actual application
(e.g. pressures, forces, torques, temperatures, masses, speeds).
Operation of the product in compliance with the relevant safety regulations is contingent on adher-
ence to the load limits.
• Take the tolerance of the tightening torques into account. Unless otherwise specified, the tolerance
is ± 20 %.
For vertical installation:
• Make sure that the slide has reached a stable position when it comes to a stop (e.g. the lowest
point or secured with external stops).
• Make sure the compressed air is properly prepared (
• Read also the documentation for your control system (e.g. CPX-CMAX).
22
Technical data).
Technical data).
Festo – DDLI-25/32/40/63 – 1402a English