Security Advices; Fitting Instructions - S&P ARTIC-400 CN Notice D'utilisation

ENGLISH
GENERAL
The ARTIC-CN fans serie is fitted with the latest technological improvements and with a nice and functional
design. Those fans have been manufactured to achieve the highest quality which assures a wide, sure and
efficient service. They have been also manufactured according the electric compatibility standards in use.
Please check that the fan is in perfect conditions and that it works perfectly since the S&P guarantee covers
any origin defect.

SECURITY ADVICES

– Check that tension matches with the shown on the characteristics plate.
– Do not use this fan inside a bathroom or a shower.
– Do not sink the fan.
– Do not unplug the fan by pulling out on the cable.
– If the cable is damaged, it must be replaced by an original spare part supplied by S&P.
– Before plugging or unplugging, be sure that the main switch is placed at «0» position.
– Unplug the fan when it is not going to be used for a long time or when you are going to do the
cleaning procedures.
– This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for their
safety. Children must be under watch to avoid that they could play with the product.
– Do not place the fan near a heat source.
– Do not introduce any object over the protection grille.

FITTING INSTRUCTIONS

(Fig. 1)
1° Loosen the fixing nut of the rear grille (clockwise) and the propeller (counterclockwise) from the
motor axis.
2° Place the rear protection grille on the motor head by introducing its 3 holes into the 3 pins on the
front part of the motor and fix the grille to the motor box with the fixing nut on the rear grille.
3° Introduce the propeller on the motor axis by introducing the central hole into the axis pin and fix it
with the fixing nut.
4° Check the propeller by turning it manually. Be sure that the propeller does not touch the security
counternut. The propeller must turn freely. If necessary repeat the previous steps.
5° Place the front protection grille by placing the hook on the upper part into the rear grille. Put the two
grilles together and press until they get well placed on the plastic ring.
6° Close the security clamp on the bottom of the front grille and fix it with the screw.
All manuals and user guides at all-guides.com
7