Table des Matières
Publicité
aileron serVo tray installation •
10
Use and 80 grit sandpaper and thoroughly rough up the hatch then use
hobby knife and scratch the surface really well. Then clean the surface using
acetone. These three steps are very important for proper bonding..
16
All manuals and user guides at all-guides.com
11
Use hobby knife and scratch the surface of all the pieces of the servo tray
that will be glued together. Using Acetone, thoroughly clean the surfaces.
12
Servo tray piece shown in above picture needs to be in the center of the servo
hatch, just below the 27mm mark and between the marked boundary lines,
just outside the mounting locations. Using Mercury M100XF CA, glue the
servo tray piece to the hatch. Apply pressure and make sure it stays vertical
until CA dries. Do not use accelerator.
Publicité
Table des Matières
