ANSMANN WFL800 Mode D'emploi page 14

• Before connecting the product with the power supply, always make
sure that the supply voltage complies with the information on the
rating plate.
• The mounting surface and materials must be able to securely hold the
product. In case of doubt, consult an expert.
• Risk of fatal injury due to electric shock! Take care not to damage
water, electricity or telecommunications lines while drilling holes. Use
a cable locator.
• This product complies with protection class IP54: Protected against the
ingress of dust into hazardous and sensitive components. Splash-
proof. Do not immerse the product in water.
The IP protection class is only ensured when the product is correctly
installed.
• Never touch the product with wet or damp hands.
• Always ensure that the power cord is not taut nor comes into contact
with sharp objects, chemicals or solvents.
• Regularly check the power cord and power plug for damages.
• To avoid hazards, the flexible exterior cord of this floodlight, if
damaged, may only be replaced by the manufacturer, its service
representative or a comparable professional.
This product complies with protection class I and must therefore
be connected to the protective earth conductor.
Risk of fatal injury due to electric shock! Improper use, operation
or installation poses a risk of potentially fatal electric shock. The
product may be connected by a professional electrician only!
Do not look directly into the beam of light.
Do not shine the light in the faces of others. Looking into the
beam of light for too long may cause damage to the retina due
to blue light.
• Safe operation cannot be guaranteed if the product shows any kind of
damage. If the product is damaged, it must be disposed of or repaired.
Deutsch |
14
Svenska | Italiano | Nederlands | Suomi | Norsk | Dansk
The safety glass is non-replaceable. If the safety glass
is damaged, dispose of the product.
English | Français | Español | Português