Uline MARSH H-1360 Mode D'emploi page 3

ADJUSTING BRUSH TANK WATER LEVEL
1. Loosen the screws on the water bottle brackets.
2. Move the water bottle brackets to a position that will
obtain the desired water level in the brush tank. Both
brackets should be in the same position. (See Figure 4)
NOTE: Lightweight tapes should be adjusted to
the low position, heavyweight tapes should be
adjusted to the high position.
3. Tighten the retaining screws on the water bottle
brackets.
ADJUSTING TAPE WEIGHT
1. Loosen the retaining screw.
2. Slide the tape weight forward to apply greater
pressure. Slide the tape weight backwards to apply
less pressure.
NOTE: Lightweight tapes will apply less water on
the tape. Heavyweight tapes will apply more
water on the tape.
3. Tighten retaining screw.
PRE-PROGRAMMED LENGTHS AND SHIFT
NOTE: There are 20 lengths pre-programmed
into the memory of the dispenser.
1. Press one of the ten length keys and the length in
black is dispensed.
2. To dispense the lengths in red, press the SHIFT key
and the corresponding length key.
REPEAT SHORT AND REPEAT LONG
The pre-programmed lengths can be stored in the
REPEAT SHORT and REPEAT LONG keys.
1. Press PROGRAM, the preferred length key and
REPEAT SHORT or REPEAT LONG. Display will flash.
Flashing stops when programming is complete or
PROGRAM is pressed to cancel mode.
NOTE: Tape cannot be dispensed in PROGRAM
MODE.
RANDOM
The RANDOM key allows users to dispense tape until the
key is released.
PAGE 3 OF 15
SET-UP INSTRUCTIONS CONTINUED
OPERATING INSTRUCTIONS
Figure 4
LOW
MEDIUM
HIGH
SHIFT KEY
NUMBER KEY
PROGRAM KEY
REPEAT LONG KEY
REPEAT SHORT KEY
RANDOM KEY
0521 IH-1360