Uline MARSH H-1360 Mode D'emploi page 2

4. Feed the tape, gummed side down, over the top
roller, under the tape guide flaps, and under the
pinch roller. (See Figure 2)
Pinch
Roller
Shaft
Cleaning
Gaps
Cutter
Assembly
FILLING WATER BOTTLE
1. Remove the water bottle from the dispenser.
(See Figure 3)
2. Remove the duckbill valve from the water
bottle. Fill the water bottle with water.
(See Figure 3)
3. Place the duckbill valve back into the water
bottle.
4. Place the water bottle back onto the
dispenser.
5. Verify that the post in the brush tank is inserted
through the duckbill valve.
PAGE 2 OF 15
SET-UP INSTRUCTIONS CONTINUED
Pressure
Top Roller
Plate
Pinch
Roller
5. Place the pressure plate over the tape and release
the pinch roller. (See Figure 2)
6. Close the top cover.
Tape
Gummed
Side of Tape
Water
Bottle
Brackets
Post
Figure 2
Tape Roll
Figure 3
Water
Bottle
Duckbill
Valve
Tape
Weight
Brush
Tank
0521 IH-1360