Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
MaxLite
WallMax Compact Open Face Wall Pack - 80W & 120W
®
Installation & Operation - Wall Mount with J-Box: (Continued)
13. Reinstall the front cover and reconnect
the terminals between the LEDs and
CCT controller.
Installation & Operation – Wall Mount with Conduit:
1. Turn off the power.
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
14. Close the fixture and secure it
with the two (2) screws removed
in step 2.
2. Use a screwdriver to remove
the screws on both sides.
5. Drill four (4) holes in the wall that
match the locations of the holes
drilled in step 7 when mounted.
WCOP Series
15. Make sure the installation is
complete before turning the
power on.
3. Open the fixture, disconnect the
connection terminals between the
LEDs and CCT controller, and
remove the front cover of the fixture.
6. Using four (4) anchor bolts (not
the wall. Note: These bolts provide
included), secure the back plate to
the structural support, anchoring the
fixture to the wall.
Page: 4
REV: 11/24/21
Publicité
Table des Matières
