Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
MaxLite
WallMax Compact Open Face Wall Pack - 80W & 120W
®
Note: Add a bead of exterior grade silicone sealant around the perimeter of the wall pack on the wall to inhibit any moisture
Installation & Operation - Wall Mount with J-Box:
from attachment bolts.
1. Turn off the power.
10. Using four (4) anchor bolts (not
plate to the wall. Note: These
included), secure the back
bolts provide the structural
support, anchoring the fixture
to the wall.
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
2. Use a screwdriver to remove
the screws on both sides.
5. Drill through the mounting holes on
the j-box template according to the
applications requirements.
WCOP Series
3. Open the fixture, disconnect the
connection terminals between the
LEDs and CCT controller, and
remove the front cover of the fixture.
6. Attach the included EVA
foam gasket onto the back
plate.
Page: 3
REV: 11/24/21
Publicité
Table des Matières
