ekwb EK-Nucleus AIO CR360 Lux D-RGB Manuel D'installation page 9

Protective Cover
Pre-applied
thermal
Compound
M3x4
AMD Mounting
Bracket
Non-abrasive
IHS
cloth
Thumb Nut
Spring
STEP 4: REMOVING THE COLD-PLATE
PROTECTIVE COVER (AMD)
Remove the protective cover from
backside of the pump unit. It is there only to
prevent damage to the cold-plate and the
pre-applied thermal compound that is on the
cold-plate.
When removing the protective cover and
proceeding with installation be careful not
to touch or damage the pre-applied thermal
compound.
STEP 5: MOUNTING-BRACKETS
INSTALLATION (AMD)
Use 4x M3x4 screws to install AMD bracket on
the pump unit.
Be careful not to touch or damage the pre-
applied thermal compound.
STEP 6: PUMP UNIT INSTALLATION
(AMD)
Wipe the CPU's contact surface (using a
non-abrasive cloth or a Q-tip as shown in the
sample image).
Align the pump unit over the mounting screws
and CPU as shown in the picture.
Place the enclosed compression springs and
thumb nuts over the mounting screws (4x). Start
fastening two thumb nuts at a time, preferably
in a cross pattern, and do not tighten them fully
until all of them are partially screwed in.
EK-AIO Nucleus 120
UNC 6-32 x 6 mm
(4x)
the
EK-AIO Nucleus 240
UNC 6-32 x 6 mm
(8x)
EK-AIO Nucleus 360
UNC 6-32 x 6 mm
(12x)
- 10 -
STEP 7: INSTALLING THE ASSEMBLY
OF FANS AND RADIATOR INTO A PC
CASE (AMD)
Attach the assembly of radiator and the fan(s)
to the PC case with the UNC 6-32 x 6mm
screws.
Radiator on top (recommended)
Vertical placement of the radiator with
tubing at the bottom (recommended)