General Safety Warnings - ekwb EK-Nucleus AIO CR360 Lux D-RGB Manuel D'installation

D-RGB Header
RGB Header
Female Connector
Male Connector
Female Male
Connector Connector
STEP B:
Plug the 3-pin D-RGB connector from the
extension cable to the D-RGB header on the
motherboard.
Please ensure that the arrow indicated on
the connector is plugged into the +5V line
as indicated on your motherboard. If you
put LED Diode to the 12V RGB HEADER
you can damage the LEDs.
Connector is the same on D-RGB and RGB
versions, but D-RGB version has 3 cables
from connector to PCB; RGB version has
4 cables. If you connect D-RGB led to
ordinary RGB header you can damage
your motherboard or LED strip.
STEP C:
Connect the female connector from the
extension cable to the male connector from
the fi rst fan in line.
Be careful to turn the micro-fi t connector
correctly.
STEP D:
In the case of the EK-Nucleus AIO CR240
D-RGB or EK-Nucleus AIO CR360 D-RGB
version, connect the second and third fan in
series with the "daisy-chain".
Be careful to turn the connector correctly.
1 2 3
Non-abrasive
Cloth
IHS

7. GENERAL SAFETY WARNINGS

First aid measures in case of:
Skin exposure to coolant: Remove contaminated clothing and rinse thoroughly with plenty of
running water or normal saline rinse. If symptoms develop and persist, seek professional medical
attention.
Eye exposure to coolant: Immediately open upper and lower eyelids, fl ush out with running water
or normal saline rinse. If irritation persists, seek professional medical attention.
Inhalation of coolant: Remove yourself from site to fresh air. If symptoms develop and persist,
seek professional medical attention.
Ingestion of coolant: Drink plenty of warm water and do not induce vomiting. In case of doubt or
if felling unwell, seek professional medical attention.
- 12 -
STEP 10: PUMP TOP ORIENTATION
(AMD)
4
Lift the top, rotate it until the EK logo is oriented
correctly, and put it back down. The magnets
will hold the top in place.
Congratulations! You have
installed your EK-Nucleus AIO.
OPTIONAL STEP! APPLYING THE
THERMAL COMPOUND
This step is relevant only in the case of a
second installation of AIO or if you have
damaged the pre-applied paste on the
backside of the pump unit. For the fi rst
installation, you don't need to apply the
additional thermal compound to the CPU's
contact surface.
Wipe the CPU's contact surface (using a non–
abrasive cloth or Q-tip, as shown on sample
photo). On a clean IHS, apply a line of thermal
compound and spread it over the whole CPU
heat spreader (IHS) with a credit card or
equivalent.
For help on how to control the D-RGB lights,
please refer to your motherboard instructions.
successfully