ASROCK P4VM900-SATA2 Mode D'emploi page 10

Table des Matières

Les langues disponibles

All manuals and user guides at all-guides.com

2.1 CPU Installation

Step 1. Unlock the socket by lifting the lever up to a 90° angle.

Step 2. Position the CPU directly above the socket such that its marked corner

matches the base of the socket lever.

Step 3. Carefully insert the CPU into the socket until it fits in place.

The CPU fits only in one correct orientation. DO NOT force the

CPU into the socket to avoid bending of the pins.

Step 4. When the CPU is in place, press it firmly on the socket while you push down

the socket lever to secure the CPU. The lever clicks on the side tab to

indicate that it is locked.

Lift Lever Up to 90°

STEP 1:

Lift The Socket Lever Up to 90°

2.2 Installation of CPU Fan and Heatsink

This motherboard adopts 478-pin CPU socket to support Intel

Celeron

CPU. It requires larger heatsink and cooling fan to dissipate heat.

You also need to spray thermal grease between the CPU and the heatsink to

improve heat dissipation. Make sure that the CPU and the heatsink are se-

curely fastened and in good contact with each other. Then connect the CPU

fan to the CPU_FAN connector (CPU_FAN1, see p.2 No. 27). For proper

installation, please kindly refer to the instruction manuals of the CPU fan and

the heatsink.

1 0

ASRock P4VM900-SATA2 Motherboard

CPU Marked Corner

Socket Marked Corner

STEP 2/STEP 3:

STEP 4:

Match The CPU Marked Corner

Push Down And Lock

to The Socket Marked Corner

The Socket Lever

Pentium

4 /

Table des Matières