Preparation - Dyna-Glo DG4WB Mode D'emploi

WARNING: DO NOT TAKE APART ANY COMPONENTS OF THE MOTOR.
Always confirm that this product, when installed, has been grounded in accordance with applicable
local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA No. 70
or the Canadian Electrical Code, CSA C22.1, when an external electrical source is being utilized
for the rotisserie motor.
1. Read all instructions before assembly, installation, and use.
2. Do not touch hot surface with bare hands.
3. To protect against electrical shock, do not immerse cord, plug, or motor in water or other liquid.
4. Close supervision is necessary when any appliance is used by or near children.
5. Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking
off parts. Do not clean this product with a water spray or the like.
6. Do not operate any appliance with a damaged cord or plug or after the appliance has been
damaged in any manner.
7. The use of other accessory attachments is not recommended by the appliance manufacturer
as it may cause injuries.
8. Do not let the electrical supply cord touch hot surfaces or hang over edge of table or counter.
9. Do not place on or near a hot gas or electrical burner or in a heated oven.
10. Caution must be used when assembling the pointed end of spit rod and the meat forks as the
ends are sharp.
11. Always attach plug to appliance first, then plug cord into the wall outlet. If the plug does not fit
in the outlet, contact a qualified electrician. DO NOT attempt to modify the plug or override
the safety feature indicated on the product's warning label and in this manual.
12. Never use this product for any purpose other than the ones specifically intended by the manufacturer.
13. Any type of fuel and/or charcoal briquettes are not to be used with this appliance.
14. Do not expose rotisserie motor to rain.
15. Always connect this product to an electrical circuit protected by a Ground Fault Interrupter (GFI).
16. A short power supply cord is provided to reduce the risk of becoming entangled in or tripping
over a longer cord.
17. Longer detachable power-supply cords or extension cords may be used if care is exercised in
their use.
18. If it is necessary to use an extension cord, always select one that has a three-pronged (grounded)
power plug that is adequate for the power rating of the unit, that has been approved for outdoor
use, and has a W-A marking.
19. Keep any electrical supply cord and the fuel supply hose away from any heated surfaces.
20. To reduce the risk of electrical shock, keep extension cord connection dry and off the ground.
21. When the rotisserie motor is not in use, remove and store in a dry environment.
22. Never connect the 3-pronged (grounded) power plug to a 2-pronged adapter.
23. Always follow all safety procedures as stated in the rotisserie and grill manuals.
WARNING: ELECTRICAL GROUNDING INSTRUCTIONS
This outdoor cooking gas appliance is equipped with a three-prong (grounding) plug for your
protection against shock hazard and should be plugged directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding prong from this plug.

PREPARATION

Before beginning assembly or operation, make sure all parts are present. Compare parts with
package contents and hardware contents list. If any part is missing or damaged, do not attempt to
assemble or operate the product.
• Estimated Assembly Time: 15 minutes
• Tools Required for Assembly (not included): Phillips screwdriver, Pliers
SAVE THESE INSTRUCTIONS
4