Seat Sling; Seat Depth Growth; Seat Depth; Tray - Sunrise Medical Sopur Easy Life i Notice D'utilisation

Seat sling

Standard seat sling
(Fig. 6.48)
The seat sling has Velcro on one side and this allows infinite
adjustment of the seat sling. To re-tension the seat sling, fold
the wheelchair slightly. Remove the screws (1) and pull the front
plugs (2) forward out of the frame. The seat sling (3) can then
be pulled forward out of the frame. By undoing the Velcro, you
can re-tension the seat sling. Refit by following the instructions
in reverse order. Make sure that after any adjustment work, all
screws are tightened correctly (see the page on torque).
ATTENTION!
To guarantee safety, at least 50 % of the Velcro surfaces must
make contact with each other.
3
1
1
Fig.6.48

Seat depth growth

Seat depth growth
(Fig. 6.49)
You can easily alter the seat depth by using the Velcro fastener
on the seat sling.
Separate sling A from sling B, set the desired position and then
push both slings back together, one on top of each other.
Fig. 6.49
Easy Life i Rev.4.0
2

Seat depth

Seat depth
By removing the clips (1), the cross-brace unit (2) can be
pushed along the frame, which then alters the seat depth
(depending on the position of the back tubes).
Make sure that the clips (1) snap into the frame holes provided.
To keep the frame as compact as possible, the seat depth can
also be adjusted by using the back tubes. To do this, remove
the screws (1 and 2) on the back tube bracket. Remove the
wheels and armrests, move the back tubes to the desired
position. Move the receiver tube for the armrests to the desired
position, (Fig. 6.50).

Tray

Tray
(Fig. 6.51)
The tray table serves as a surface area. Your dealer must carry
out a one-off adjustment to the therapy tray so that it matches
the seat width. When carrying out a function test, the user must
be sitting in the wheelchair.
Fig. 6.51
Fig. 6.50
47