Winning appliances WolfI Guide D'installation page 2

CONVECTION STEAM OVENS
Contents
Convection Steam Ovens
2
Specifications
2
Installation
4
Troubleshooting
5
Features and specifications are subject to change at any
time without notice. Visit wolfappliance.com/specs for the
most up-to-date information.
|
2 English
Important Note
To ensure this product is installed and operated as safely
and efficiently as possible, take note of the following types
of highlighted information throughout this guide:
highlights information that is especially
IMPORTANT NOTE
important.
CAUTION indicates a situation where minor injury or product
damage may occur if instructions are not followed.
WARNING states a hazard that may cause serious injury or
death if precautions are not followed.
Save these instructions for the local
IMPORTANT NOTE:
electrical inspector.
Product Information
Important product information including the model and
serial number are listed on the product rating plate. The
rating plate is located on the left side of the front face frame.
The oven door must be open to view the rating plate. Refer
to the illustration below.
If service is necessary, contact Wolf factory certified service
with the model and serial number.
RATING PLATE
Rating plate location.
SPECIFICATIONS
Installation Requirements
The convection steam oven can be installed in a standard or
flush inset application. A minimum base support of 45 kg is
required. The electrical supply for the oven must be located
in an adjacent cabinet.
For standard installations, face trim will overlap stiles and
rails. Refer to the chart below for trim overlaps.
For flush inset installations, a minimum 3 mm reveal is
required on all four sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°. Finish the edges
of the opening. They may be visible when the door is open.
If the convection steam oven is installed above or below a
Wolf E series oven in a flush inset application, a 6 mm reveal
is required.
TRIM OVERLAP
OVERLAP 610 mm MODEL 762 mm MODEL
Top 5 mm
Bottom 0 mm
Sides 18 mm
5 mm
0 mm
98 mm