Accessories; Installation - Kenwood KDV-S221P Mode D'emploi

Accessories

1
2
3
4
5
6
7
8
¤
• If the fuse blows, first make sure that the wires have not
caused a short circuit, then replace the old fuse with one
with the same rating.

Installation

Installation using the brackets
..........1
..........1
..........2
Installation using the Velcro tapes
..........5
..........4
Carpet
¤
..........2
• Do not use your own screws. Use only the screws provided.
If you use the wrong screws, you could damage the unit.
• Do not install the unit to an unstable place and a place
where it vibrates.
• You can mount the unit at any angle between the regular
..........1
horizontal position and the vertical position on its back (0°
through 90°). You cannot mount the unit with the disc slot
facing downwards, angled or upside down.
..........1
Tapping Screw 5
(Φ5 x 20 mm)
Bracket 3
Semusu Screw 4
(M4 x 5 mm)
Velcro tape 6
19
|
English