Commissioning; Attaching The Grinding Wheel - Metabo W 8-115 Mode D'emploi

17026938_1009 kl WS W 8_115 ff NAFTA Protect.book Seite 10 Mittwoch, 21. Oktober 2009 4:34 16
ENG ENGLISH
• Metabo dust protection technology for an
extremely long machine service life
• Ergonomic housing design with distinctive
handholds for maximum control when cutting
and roughing
• Metabo S-automatic safety clutch
• Metabo "Quick" tool change
(on machines with "Quick" clamping nut (1))

6 Commissioning

Before plugging in, check to see that the
rated mains voltage and mains frequency,
as stated on the rating label, match your power
supply.
6.1 Attaching the additional handle
Always work with the additional handle
attached (10)! Attach the additional handle
on the left or right of the machine and secure.
6.2 Attaching the safety guard
(for work involving grinding wheels)
For reasons of safety, the safety guard (11)
should always be attached when roughing
work is performed.
For reasons of safety, the special parting
guard should always be attached before
parting work is performed (see chapter 11 Acces-
sories).
See illustration on page 3.
- Push and hold the lever (15). Place the safety
guard (11) in the position indicated.
- Release the lever and turn the safety guard until
the lever engages.
- Push the lever and turn the safety guard until the
closed section is facing the operator.
- Make sure that the guard is seated securely: the
lever must engage and you should not be able to
turn the safety guard.
7 Attaching the grinding
wheel
Disconnect the mains plug before changing
any accessories. The machine must be
switched off and the spindle at a standstill.
For reasons of safety, attach the parting
guard before performing parting work
(see chapter 11 Accessories).
10
All manuals and user guides at all-guides.com
7.1
- Press in the spindle locking button (4) and turn
7.2
- Locate the supporting flange (2) for type 1 cutting
- Position the cutting disc or the grinding disc on
7.3
8 mm (5/16") ! In this case, use the clamping nut
(13) with 2-hole spanner (14).
- Lock the spindle (see chapter 7.1).
- Position the "Quick" clamping nut (1) on the
- Tighten the "Quick" clamping nut by turning
- Turn the grinding wheel firmly clockwise to
Locking the spindle
the spindle (3) by hand until the spindle locking
button engages.
Placing the grinding wheel in position
2
2
12
discs, (2) for type 27 wheels 5" diameter or
smaller, or (12) for type 27 wheels 6" diameter,
as illustrated, ensuring that the supporting flange
cannot turn on the spindle.
the inner flange, as illustrated, ensuring that the
cutting disc is supported evenly by the
supporting flange. When cutting, the sheet metal
flange on the cutter disc should be resting on the
inner flange.
Securing/Releasing the "Quick"
clamping nut (depending on features):
For Type 27 grinding wheel use only
Securing the "Quick" clamping nut (1):
Do not use the "Quick" clamping nut if the
accessory has a clamping shank thicker than
spindle (3) so that the 2 lugs engage in the
2 grooves on the spindle. See illustration on
page 3.
clockwise by hand.
tighten the "Quick" clamping nut.