sunjoe GTS4001C Manuel De L'opérateur page 23

Fig. 45
Lock tab
3. To remove the hedge trimmer head, release the On/Off
switch and remove the battery. Unlock the assembly lock.
Push the lock tabs on both sides, and pull the hedge
trimmer head out (Fig. 45).
Operation
Starting and Stopping
1. Slide the battery into the battery compartment until it
clicks to lock it into position (Fig. 46).
Fig. 46
2. To turn the pole hedge trimmer ON, push and hold the
safety lock switch (located on the handle) forward with
your thumb and then squeeze the On/Off switch with
your fingers. Once the tool is running, you can release the
safety lock switch (Fig. 47).
Fig. 47
3. To turn the tool OFF, release the On/Off switch (Fig. 47).
Adjusting the Telescoping Pole
This machine is equipped with a telescoping pole which can
telescope from 3.7 ft (1.1 m) to 5.3 ft (1.6 m). To adjust the
telescoping pole, follow the instructions below.
Assembly lock
Battery
Safety lock
switch
On/Off switch
1. Disconnect the hedge trimmer from the power supply by
removing the battery from the compartment.
2. Unclip the telescoping lock to release the pole. Extend the
pole to the desired length (Fig. 48).
NOTE: Push poles toward each other to shorten the pole
or pull them away from each other to lengthen the pole.
Only extend the pole to the minimum length required to
reach the hedges.
Fig. 48
Pull
3. Lock the pole in position by closing the telescoping lock
(Fig. 49), and ensure that the pole is secured.
Fig. 49
m
WARNING!
Failure to lock the telescoping lock as
directed could result in personal injury.
Adjusting the Multi-Angle Head
The hedge trimmer head can be rotated for 10 different cutting
angles for -45º, -30º, -15º, 0º, 15º, 30º, 45º, 60º, 75º, and 90º.
Follow the below instructions to adjust angles.
1. Rotate the trimmer head to the desired cutting angle while
pressing the rotating buttons located on both sides of the
unit simultaneously (Fig. 50).
Fig. 50
Front side
23
Pull
Telescoping lock
Telescoping lock
Rotating
buttons
Back side