Operating Tips - sunjoe GTS4001C Manuel De L'opérateur

To Remove the Auxiliary Handle
1. Disconnect the leaf blower from the power supply by
removing the battery from the compartment.
2. Unscrew the auxiliary handle lock knob and remove it and
the bolt, then the auxiliary handle can be pulled out
(Fig. 39).
Fig. 39
Bolt
3. Re-assemble the auxiliary handle lock knob and the bolt
on (Fig. 40).
Fig. 40
To Adjust the Position of the Auxiliary Handle
1. Disconnect the leaf blower from the power supply by
removing the battery from the compartment.
2. Remove the auxiliary handle lock knob, the bolt, and the
auxiliary handle. Use a screw driver to remove the two
screws that used to fix the auxiliary handle loops.
Remove the loops from the pole (Fig. 41).
Fig. 41
Bolt
Auxiliary
handle loop
3. Re-assemble the auxiliary handle loop on the desired spot
on the pole by using the two screws, and put back the
auxiliary handle, the auxiliary handle lock knob and the
bolt (Fig. 41).
To Adjust the Angle of the Auxiliary Handle
1. Stop the leaf blower by releasing the On/Off switch.
Auxiliary handle
Auxiliary handle
lock knob
Auxiliary
handle
Auxiliary handle
lock knob
Auxiliary
handle loop
Screws
2. The auxiliary handle can be adjusted in -45°, 0°, 45°.
Rotate the auxiliary handle lock knob to unlock the handle,
and then rotate the handle to the desired angle (Fig. 42).
Fig. 42
Auxiliary handle
lock knob
3. Rotate the auxiliary handle lock knob back to lock the
handle in position.

Operating Tips

m
WARNING!
Use the pole blower only in daylight or
good artificial light.
• When using the pole blower, plant your feet firmly on the
ground and place your dominant hand on the handle to
control the unit. Use your other hand to grab the pole on
the soft grip to steady the unit.
• Wear personal protective equipment during your work
session. This includes boots, safety glasses/goggles, ear
defenders, long pants and a long-sleeve shirt.
• Make sure the blower tube is not directed at anybody or
any loose debris before starting the unit.
• Verify that the unit is in good working condition. Make sure
the tubes and guards are in place and secure.
• Keep a firm grip on the unit while in use.
• To reduce the risk of hearing loss associated with
increased sound levels, hearing protection is required.
• Operate power equipment only at reasonable hours—not
early in the morning or late at night when people might be
disturbed. Comply with times listed in local ordinances.
Usual recommendations are 9:00 am to 5:00 pm,
Monday through Saturday.
• To reduce noise levels, limit the number of pieces of
power equipment used at any one time and operate
power blowers at the lowest possible speed setting
necessary to do the job.
• Use rakes and brooms to loosen debris before blowing.
• In dusty conditions, slightly dampen surfaces.
• Conserve water by using power blowers instead of hoses
for many lawn and garden applications, including areas
such as gutters, screens, patios, grills, porches and
gardens.
21