SilverCrest 37702 Instructions D'utilisation page 16

Safety Devices
Caution
Safety devices protect the user and must not be
modified or bypassed.
Pressure controller
The pressure controller keeps the boiler pres-
sure during the operation as constant as possi-
ble. The heating is turned off if the maximum
operating pressure of 4 bar is reached in the boil-
er and is reactivated in case of a pressure drop
in the boiler due to steam tapping.
Safety thermostat
If the boiler thermostat fails and the appliance
overheats, then the safety thermostat turns off
the appliance.
Please contact your local CUSTOMER SERV-
ICE to arrange for the reset of the safety thermo-
stat.
Safety lock (A4)
The safety lock seals the boiler against the
steam pressure that builds up in the boiler. If the
pressure controller is defect and the steam pres-
sure in the boiler rises, a pressure control valve
in the safety lock opens, and steam is emitted
through the lock to the outside.
Please contact your local CUSTOMER SERV-
ICE before you put the appliance into operation
again.
Symbols on the machine
Steam
CAUTION - Danger of scalding
16 English
All manuals and user guides at all-guides.com
Hot water may drip out of the accessory parts
while you are detaching them! Never detach ac-
cessory parts while steam streams out - risk of
scalding!
Note: If you always use usual commercial dis-
tilled water it is not necessary to descale the boil-
er.
Caution
Do not use condensation water from the drier!
Do not fill in detergents or other additives!
Operation
Attaching the Accessories
Illustration
Insert steering roller (A9) and transport
wheels (A8) and lock them.
Tightly insert the steam plug (B6) into the ap-
pliance connector (A1). The plug must click
into place audibly.
To detach: Press the cover of the appliance
connector to the bottom and disconnect the
steam plug from the appliance connector.
Illustration
Connect the required accessories to the
steam gun (B1).
Insert the open end of the accessory on the
steam gun and push onto the steam gun until
the unlocking button (B2) of the steam gun
locks into place.
Illustration
Use the extension pieces (E1) if necessary.
To do so, connect one or both extension
pieces to the steam gun (B1). Insert the re-
quired accessories on the free end of the ex-
tension piece.
Removing the Accessories
Danger
Push the steam lever locking (B3) to the front
(steam switch blocked).
Illustration
To detach the accessory parts, press the un-
locking button (B2 or E2), and pull the items
apart.
Fill up with water
Remove the safety cap (A4) from the device.
Empty remaining water from boiler.
Fill the boiler with a maximum of 1.2 liters of
fresh tap water.