Waeco PerfectView M70L Instructions De Montage Et De Service page 26

_RV-70.book Seite 26 Freitag, 15. Dezember 2006 4:15 16
Mounting the LCD monitor
Check beforehand that there is sufficient room for the drill head to come out on
the other side (fig. 2, page 4).
Bear in mind the weight of the monitor. Provide reinforcement if necessary
(larger washers or plates).
Ensure that you can lay the connection cables to the monitor.
To perform the installation, proceed as follows:
➤
Mount the monitor and the mounting rail (fig. a 1, page 6) onto the monitor
base and secure it with the knurled nut (fig. b 1, page 7).
➤
Position the monitor and the attached monitor base fortesting.
➤
Mark the outlines of the corners of the monitor base on the dashboard.
➤
Unscrew the monitor base from the monitor.
➤
Hold the monitor base within the outlines marked beforehand and mark three
different drilling points.
➤ At the points marked beforehand, drill holes of ∅ 2 mm.
➤
Screw the monitor base on with the 4 x 20 mm self-tapping screws.
➤
Mount the monitor and the mounting rail (fig. a 1, page 6) onto the monitor
base and secure it with the knurled nut (fig. b 1, page 7).
6.3 Connecting the monitor to an electricity supply
The circuit diagram for the LCD monitor can be found in fig. c, page 7.
No. in
Description
fig. c, page 7
1 Monitor
2 13-pin socket
3 Monitor line
4 13-pin plug
5 12–24 V positive cable (red): connection to the positive pole of
the ignition (connected positive, terminal 15)
6 Earth cable (black): connection to the negative pole of the
power source
7 6 pin DIN socket (connection to video source 1)
8 6 pin DIN socket (connection to video source 2)
9 Cable (green): control input for the connection to the reversing
lights (programmable for V1 and V2)
10 Cable (white): control input from indicators for the side-view
camera (video input V2)
26
All manuals and user guides at all-guides.com
PerfectView M70L