Acova Versus Notice D'utilisation page 18

EN
The "Night" mode temperature setting cannot be higher than the "Comfort"
mode's one.
Example : If the "Comfort" mode's temperature has been set to 25 degrees,
when switching to "Night" mode and wanting to set the temperature, once it reaches 25
degrees, the temperature will not rise, even when pressing the "Plus" button.
Antifreeze Mode
Go to "Antifreeze" mode, the temperature is fixed to 7 degrees, by pressing the
"Plus" or "Minus" buttons, the temperature cannot be neither risen nor reduced.
Chrono Mode
Go to "Chrono" mode, the LCD display will be showing temperature, date, time
and state of the daily program.
See chapter 4.4 to set the program.
Pilot-Wire Mode
Go to "Pilot-Wire" mode – the device will recognise the commands received
from the Pilot-Wire (Comfort / Nigh / Antifreeze / ECO / Stand-by)
Boost mode 2 hours
This mode can be used to quickly warm the room or speed up the drying of the
towels.
Press the «Boost 2h» button until the display shows the
The unit will heat at full power for 2 hours for a maximum temperature of 30° C
in the room. At the end of the two hours the unit automatically returns to its previous
operating mode. It is possible to exit the boost and change the operating mode at any
time by pressing the «Boost 2h» button again.
Comfort
mode
Press
Boost 2h
key
34
All manuals and user guides at all-guides.com
icon.
2 hours Comfort
mode mode
Press
Boost 2h
key
Stand-by Mode
In any mode, by pressing the «Stand-by» button, the remote control will go into
stand-by mode and the device will stop operating.
By pressing this button again, the remote control will go back to the previous
mode.
Comfort
mode
« Window open » Mode
In this mode, your radiator will be able to detect a significant drop in tempera-
ture, caused by a window standing open in winter, for instance. It will then adapt its
operation automatically so that you make energy savings.
In this case the device switches off the resistance for up to 30 minutes or until
the temperature rise in the room indicates that the window has been closed.
By simultaneously pressing the «Window open detection» button and the «-»
button, the open window sensor will be activated. The
Pressing the «Window open detection» button and the «-» button simulta-
neously deactivates the function. The
IMPORTANT:
Your radiator should be placed close to the opening with no furniture or other
object nearby, to make the best use of this function. The quality of the window
open/closed function depends on a number of factors, such as the position
of the appliance, how fast the temperature in the room rises/falls, the type of
window, etc.
40019728 12/2019
Stand-by
mode
Press Press
stand-by stand-by
key key
icon appears on the screen.
icon disappears.
EN
Comfort
mode
35