Troubleshooting - Furrion FSRE17SA-BL Consignes D'utilisation

Troubleshooting

Before calling for service, review this list. It may save you both time and expense. This
list includes common experiences that are not the result of defective workmanship or
material in your appliance.
Problem
Surface burners do not
light
Surface burner flame
burns half way around
Surface burner flame is
orange
Possible Causes / Solution
Surface Control Knob has not been completely turned to
and turn the Surface Control knob to
turn control to desired flame size.
Ensure gas supply valve is open.
Burner ports or slots are clogged. With the burner off, use a small-gauge wire
or needle to clean ports or slots.
Low gas supply level in cylinder.
Battery power insufficient. Unscrew igniter cap and replace battery.
Moisture is present on the burner, dry burner thoroughly.
Burner ports or slots are clogged. With the burner off, clean ports with a
small-gauge wire or needle to clean ports or slots.
Moisture is present after cleaning. Lightly fan the flame and allow burner to
operate until flame is full. Dry the burners thoroughly.
Dust particles in main line. Allow the burner to operate a few minutes until
flame turns blue.
In coastal areas, a slightly orange flame is unavoidable due to salt air.
position. Push in
position until burner ignites and then
26