Control Knobs - Bosch NGMP077UC Instructions

Burner grates
!

Control knobs

"
Small burner with an output of up to
#
3,400 BTU/h (1 kW) OptiSim
see "OptiSim® Burner Cap Placement and
OptiSim® Burner Cap Installation" in section
~ "Accessories" on page 12
Control Knobs
Each control knob is marked with the burner it controls.
You can use the control knobs to set the output required
in each case to various positions between the maximum
and the minimum settings. Never try to switch directly
from position "off" to position 1 or from position 1 to
position "off".
WARNING
9
Failure to operate knobs properly may result in
personal injury and damage to the appliance.
Indicators
Burner controlled by control knob
'
off Burner switched off
Highest power setting and electric ignition
hi 9
1 lo Lowest power setting
feature
®
Medium burner with an output of up to
$
6,000 BTU/h (1.76 kW)
Large burner with an output of up to
%
10,300 BTU/h (3.02 kW)
Dual-flame burner with an output of up to
&
14,300 BTU/h (4.19 kW)
Serial Number/Rating label location
'
(right front underneath)
Indicators
1 sim Small burner
Use this setting with the OptiSim
1 sim Dual-flame burner
Lowest power setting
For dual-flame burners, the inner and outer flames can
be controlled separately. The available power levels are
as follows:
cap.
®
Inner and outer flame on
full power.
Outer flame on low power,
inner flame on full power.
11