Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
BATTERY OF REMOTE CONTROL
1
Open the battery compartment. Insert one new battery of type CR2025 observing the + and –
polarities as indicated on the battery and inside the battery compartment.
INSTALLATION
Place the hi-fi system and loudspeakers on an even, horizontal and steady surface. The speakers
2
should be placed one to the left and one to right of the hi-fi system.
Connect the cinch-plugs of both loudspeakers to the cinch-sockets.
3
Put the end of wire aerial up to receive at best signal strength. Connect the power plug to the
4
mains.
CLOCK SETUP
1. When product is connected with mains, 0:00 appears on the display in standby mode.
2. Press and hold CLK SET for 2 seconds. Select with
confirm with CLK SET.
3. Set the hours and minutes each with the
SETTING ALARM
Note:
• The alarm can only be set when the product is in off mode (standby)
• Ensure the time is set correctly
ALARM 1
1. Press and hold the ALARM1 button (AL1 on the remote control) until the
time flash on the display.
Note: If no settings done within 5 seconds the display will turn off into standby.
2. Set the hours and minutes each with the
the remote control).
3. Use
or
to select one of the below alarm functions:
BELL > tun > CD > USB
4. Confirm with ALARM1 button (AL1 on the remote control).
5. Press ALARM1 button (AL1 on the remote control) to activate or de-activate the alarm.
ALARM 2
For setup, switching on/off of ALARM 2 follow the instructions as given for setup of ALARM 1. But instead
of pushing ALARM2 button (AL2 on the remote control) push the ALARM1 button (AL1 on the remote
control).
STOP ALARM
1. Snooze function: Press SNOOZE button to suspend alarm sound for a few minutes. The alarm will
start again after approx. 9 minutes. The set alarm mode will remain flashing on the display.
2. Press STANDBY to stop alarm. Press ALARM1 or ALARM2 to cancel (de-activate) alarm.
IM_OMH 460BT_A_171113_V05_HR.indb 15
All manuals and user guides at all-guides.com
15
buttons and confirm each bz pressing CLK SET.
or
or
. Confirm the each with ALARM1 button (AL1 on
or
buttons the time format 24H /12H and
1
symbol and the alarm
EN
13/11/17 1:47 pm
Publicité
Table des Matières
