Haverland RC 4 E Manuel D'installation Et Utilisation page 33

FIG. Nº. 8
WALL
TRANSMITTER
2
FLOOR
WALL
3
TRANSMITTER
FIG. Nº. 11
SCREWS
FIG. Nº. 10
-
You have just installed the HAVERLAND Thermal Transmitter. We
hope it satisfies your heating needs.
- Take the two 6 x 40 mm screws and
screw each one of them lightly on
both supports (Point 1 Fig. 9).
- Then take the appliance in such way
that the controls panel is on the right
side. Incline the appliance with the
upper part towards you.
- Place the transmitter on the lower
side of the wall separators (Point 2
Fig. 10).
- Move the transmitter carefully towards the
left or right till it is centralized and fixed on
the two canals which are on its back.
Place the transmitter vertically and once it
-
is parallel to the wall, let it fall gently till the
upper separators get into both canals
(Point 3, Fig. 11).
- To have the transmitter perfectly fixed to
the wall, screw completely the 6 x 40 mm
screws in the upper part of the separators
(Point 1, Fig. 9).
- Make sure that the transmitter is perfectly
fixed to the wall to avoid future risks.
- Then connect the plug to a nearby power
supply (socket).
42
FIG. Nº. 9