Haverland RC 4 E Manuel D'installation Et Utilisation page 27

PLAN CF
The is a heating plan designed for offices and working places.
This plan can be configured by you according to your requirements in case the
configured plans do not fit your needs.
As you can see in the Table, the Comfort periods are common for most of the users.
The Comfort Temperature TC and the Economy Temperature TE can be set by
you according to your needs
Living room .......................... TC = 21 ºC
Children's room .................... TC = 20 ºC
Offices and work places ....... TC = 21 ºC
The thermal transmitter is configured with the following parameters at its
manufacture:
Comfort Temperature
Heating plan = Plan 01 (General Use plan)
CONNECTION, DISCONNECTION , "WARM-UP" MODE AND "STANDBY" MODE
x CONNECTION THE TRASMITTER:
Insert the mains power plug into the wall socket. Led on the display
panel will illuminate indicating that the thermal transmitter in
connected to the mains power supply and in "standby" mode. (TABLE 2).
x SWITCHING TO "WARM-UP" MODE:
Press the button
required for controlling the thermal transmitter are provided on the
control panel.
x SWITCHING TO "STANDBY" MODE:
Press the button
display panel. This mode will maintain all the program parameters that have been
defined by the user (current date and time).
x DISCONNECTION THE TRANSMITTER:
Remove the mains power plug from the wall socket. If the switch-off time exceeds
twenty minutes, only the current date and time will have to be pre-programmed (by
following the steps in the "Basic Programming" section). The meanings of the various
LED indicators are given below:
.
19.0 C
LED
LED
LED
LED
PROG
.
19.0 C
.
We suggest the following Comfort temperatures:
= 22 ºC Economy Temperature
.The display will light up. All the information
. The appliance will indicate this mode by means of a LED on the
TABLE 2
THE TRANSMITTER IS IN "STAND-BY" MODE
THE TRANSMITTER IS ON AND THE ROOM TEMPERATURE IS 19.0ºC
THE TRANSMITTER IS IN THE COMFORT PERIOD
THE TRANSMITTER IS IN THE ECONOMY PERIOD
IT IS IN THE MANUAL MODE
THE TRANSMITTER IS PROGRAMMING
THE DISPLAY MARKS A TEMPERATURE AND THERE AN INTERMITTENT POINT ON THE
RIGHT SIDE. THE TRANSMITTER IS HEATING UP AND THE ROOM TEMPERATURE IS
19.0ºC.
Bedrooms ........................ TC = 18 ºC
Bathrooms ...................... TC = 23 ºC
= 18 ºC
L S
P1 P2 P3
M D
X
J
V
OK
PROG
HAVERLAND