Dometic FRIGO DC Notice D'utilisation page 14

All manuals and user guides at all-guides.com
Notes on use
I
NOTE
If the optional door contact switch is not installed, the refrigeration system must
be manually switched off during loading and unloading.
Before you start loading the vehicle, the cargo space must be cooled down to
the correct temperature level and must be loaded only with properly chilled
goods in order to maintain a continuous chain of refrigeration.
➤ Switch the refrigeration system on, chapter "Switching on the refrigeration
system" on page 7.
➤ Cool down the cargo space to the correct temperature level, chapter "Set-
ting the target temperature for the cargo space" on page 9.
➤ Switch the engine off during loading.
6
Fig. 6: Air circulation in the refrigerator compartment
➤ During loading, pay attention to the following:
– The air cooled by the evaporator (fig. 6 1) must be able to circulate
freely.
– The outlet area (fig. 6 2) of the evaporator must be completely free and
must not be covered by chilled goods.
– The loading of chilled goods (fig. 6 3) may only extend to approxi-
mately 30 cm below the storage area ceiling.
– The air inlet area (fan) (fig. 6 4) of the evaporator must be completely
free and must not be covered with chilled goods.
14
1 2
4 3
Frigo DC
EN