Steinbach HJ3012 Notice D'utilisation page 37

Installing the buoyancy aids
1. Remove the filters.
2. Remove the four screws on the top part
3. Take the top part
8
4. Stick two of the self-adhesive buoyancy aids
diagonally opposite each other on the
5
inside of the top part
Should the device still not float sufficiently,
stick on two additional buoyancy aids next to
the ones already installed.
5. Replace the top part
again with the four screws.
6. Now reinsert the filters.
The buoyancy aids are installed.
Placing the device in the pool
1. Completely unroll the floating cable
place it next to the pool without twisting.
2. Hold the device by the handle
slowly into the water (tipped slightly forward)
until all the air has escaped.
3. Let the device sink to the bottom while you
slowly feed more floating cable
device in a controlled manner.
Make sure that the device lands on the bottom
of the pool on its underside and that cleaning
can start without obstruction towards the
center of the pool.
The device is in the pool.
Connecting the control unit
1. Only let as much of the floating cable
the pool.
.
8
off.
.
8
and screw it down
8
and
7
and lower it
9
to lower the
7
into the water so that the device can reach all the spots in
7
5
8
6
5
7
37