urmet domus 1092 Mode D'emploi page 9

5. Line Lock/Int Sync: in a multi-camera system, all incoming video signals must be in synchronism or
mixing and switching between cameras will cause frame roll. By setting the dip switch INT/LL to LL
position, the camera will synchronize with the mains frequency. Thanks to this feature cameras using
the same power supply line can be synchronized with one another. Also you can adjust the V-PHASE
to let every camera be in phase. For those who want to let camera be in Int Sync mode, just set dip
switch to INT position.
6. Automatic white balancing. Possible selections: "AWB"→"ATW".
AWB: the 1092/102 camera implements an automatic white balancing circuit which is capable
of correcting the colour tones as environmental light conditions change.
ATW: white balance is performed in auto tracking mode. This mode automatically balances
the white level by analysing a wide range of colours.
AUTO-IRIS PLUG
Auto-Iris plug PIN definition
PIN VIDEO
DC 12v DAMP (-)
1
NC DAMP (+)
2
IRIS DRIVER (+)
3
GND DRIVER (-)
4
AUTO-IRIS LENS FOCUSING PROCEDURE
1. Fit the optics on the camera.
2. Position the VIDEO/DC switch according to the lens employed.
3. Connect the wire to the Auto-Iris connector.
4. Turn the LEVEL trimmer to H until the picture is white.
5. Position the ES switch to ES: the picture appears out of focus.
6. Adjust the focus.
7. Position the ES switch to NOR: the picture can be white.
8. Turn the LEVEL trimmer to L until the picture appears well lit.
9. Turn the back-focus adjustment ring and repeat the operation from point 4 if focus is not correct.
DS1092-006
All manuals and user guides at all-guides.com
1 3
DC
2 4
Lenses
IMPORTANT:
consumption of 50 mA.
Urmet series 1090 AUTO-IRIS DC DRIVER lenses may
be directly connected to the camera.
Shift the wire from pin 2 to pin 3 on the lens
connector if a Urmet Domus 1090 AUTO-IRIS VIDEO
DRIVER lens is used.
must have a maximum
9