Getting Started - Ribimex Ribitech PREM1600 Manuel D'instructions Et D'utilisation

IV. GETTING STARTED
Before any intervention on product, ensure that product is disconnected from its
power source.
4.1- Installing the Shaft and Mixing Tool
1- Fig.2: Take both parts: shaft (7) and mixing tool (6).
2- Fig.3: Assemble both parts together
3- Fig.4: Tighten with a wrench
4- Fig.5: Insert mixing tool in mixer connection point (8)
5- Fig.6: Tighten with a wrench
Note : Before use and during use, periodically check the hex screw is securely tighten.
Fig.2
4.2- Starting and Stopping (ON/OFF switching)
The trigger switch (3) located on the handle incorporates a safety feature to prevent accidental
starting.
To start the machine, press the safety switch, and then squeeze the trigger switch (3).
To stop the machine, release the trigger switch (3).
4.3- Variable Speed
The variable speed selector (9) is located on the inner handle.
Simply rotate the dial to increase or decrease the speed.
Ensure that speed is adapted to work.
4.4- Speed shift I-II
The mixer is fitted with a speed switching knob (9) to adjust the
speed to different mixing materials.
Change the speed by turning the knob selector in position I or II.
Before changing speed, ensure that tool is stopped and
disconnected from its power source.
If speed shift knob is difficult to change, slightly turn the shaft
paddle and then try to change speed.
V. OPERATION
5.1- Intended use:
- The product is intended for domestic use indoors or under shelter.
- The product is intended for mixing paint, lacquer, mortar...
- Do not use tool for any other use outside the scope of this manual.
Fig.3 Fig.4 Fig.5 Fig.6
Fig.7