Ribimex Ribitech PREM1600 Manuel D'instructions Et D'utilisation page 14

d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool. Power tools are dangerous in the
hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts, breakage of
parts and any other condition that may affect the power tool's operation. If damaged, have
the power tool repaired before use. Many accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these instructions,
taking into account the working conditions and the work to be performed. Use of the power
tool for operations different from those intended could result in a hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
(B) Additional safety rules for electric mixer
a) Recommendation for the operator to wear hearing protection. Wear ear protectors with
drills. Exposure to noise can cause hearing loss.
b) Hold the power tool with a firm grip with both hands (by the handles) and keep a good
balance. The tool is best guided with both hands. If the mixing tool gets blocked, a strong torque
reaction may occur.
c) Secure the mixing container. Never hold the mixing container in your hands or across your
legs or against your body. A secured mixing container with clamping devices is held more secure
than by hand. An unstable mixing container can cause loss of control of the tool and/or injury.
d) Never grasp the tool (mixing tool or shaft) while in motion and never place your hands too close
to the spinning shaft or mixing tool. Injury hazard.
(C) Special warnings when using the product
1. Become familiar with the controls and the proper use of the tool.
2. Keep children and bystanders away
Do not let bystanders touch the tool or its power cable or the extension cord.
All bystanders (esp. children) should be kept away from tool and work area.
Keep the product away from children or from their environment. Never allow children to operate
the tool. Children should be supervised to ensure that they do not play with the tool.
3. The use of this product is forbidden to children.
4. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use
of the product by a person responsible for their safety.
5. Do not use tool if damaged, eccentric or vibrating.
Start operating tool with mixing blade inside material.
6. Observe the rotating direction.
Always hold tool firmly to avoid kickbacks.
7. Never seize or touch the shaft of mixing blade during operation
8. Always stop the tool before putting it down (note: Ensure that mixing blade is no longer moving
when you put down the tool)
Warning! The mixing blade continues to rotate after releasing the switch. Ensure that mixing blade
come to a stop before putting down product.